It's all about the Software

Are you using the noise blanker in the receive pane or the one on the home tab of the top ribbon bar? I have never found the one on the receiver pane to do anything, I assume it applies only to the bandpass similar to the other settings on that pane. However the one on the home tab works very ...

Hi Jdow,

Yes I am using the latest 3.3 from febuary. It has been persistent ever since I started using SDR console but happens more often now that i've added a midi dj board for buttons and sliders, so I figured I'd post about it. I didn't realize it is a long-standing bug.

Thanks!
K1FSY

Hello, I have been experiencing this bug for a while but recently noticed that I can easily recreate it just by quickly switching back and forth between receivers. Here is what happens:

1. Create two or more virtual receivers (i usually have 3 open) with different settings. In my testing I am ...

If you are using cuda support try turning it off before pressing play and see if it works with CPU. I started having GPU issues with later releases but switched to cpu without issue. It would lock up though and have to be killed.

Helllo, recently tried out the MIDI functionality which is really nice. Thanks for that. I have found that if I make a slider for volume control that has a range of 0 to 127, the software detects it properly and sets the values in the midi config but the volume is mapped to the raw value, as such ...

Agreed on the need for a few more MIDI controls exposed, such as range for squelch slider and a single for squelch toggle, RIT like you mentioned, and singles for switching between Normal/DX/Other mic profiles would be a good start!

Hi Simon,

Yes this was was with the latest 3.3 beta. I'm using 384khz bandwidth with an HL2. It was working fine (as in it was actually working in CUDA mode) just prior to updating the drivers from and rebooting. Once I rebooted it hung when connecting the radio and I quickly tracked it back to ...

Hello! I was having an issue with the cuda fft support where it seemed like the cuda driver would fail and the cpu driver would take over. This was noticeable because the waterfall noise floor would move faster in cpu mode, and the noise floor increased about 2dB. Stop/Start of the radio would ...

Thanks for the detailed reply Max, this makes sense. I'll probably re-adjust the input gain on the transverter to compensate as you have.

Hello! I'm working on my CW and I have a hardware keyer (winkeyer) for computer control and paddle control. I have noticed that when using it on the PTT/KEY jack on the front of the Hermes Lite that it always runs full power output. I was able to lower the power very insignificantly with the "OP ...