It's all about the Software

Hi
Installed the software. Tested the loop back yesterday. Worked fine.
Today I get an error message. Any idea how to narrow down the problem?
The CPU is idling along.

73

Frank ZS6GE

I've put a small SDR console remote control project on hold due to some bugs in the TS-2000's RS232 remote control protocol (as well as some other limitations that prevent interaction with certain features).

I had considered trying to combine the...

Apologies if this has been reported before. The short of it is I'm monitoring 3 conventional channels at the same time, one SDR, 3 receivers inputting to 3 virtual audio cables. Trying to save this configuration into my favorites list. I've ensured...

Hi All,

After some years on a small N95 W10 / W11 NUC in my computer room, the forums are now hosted professionally using Akamai , I'm sure you notice the difference in speed - was ~15 MB/s up, now 4GB/s up, that's 250x faster! Using professional...

With Auto Mute disabled, Tracking enabled, when I key the Xiegu external mic PTT and transmit, several seconds or more into the transmission, the SDRC stops the audio, then the Waterfall goes dark and the spectrum drops in magnitude. Just like the...

I'm very confused why binaural is available for AM and SAM, but not DSB.

SAM-Binaural makes sense in phase-locking the (virtual) CIO to the *strongest* carrier.
An unlocked DSB-Binaural alternative would be useful for resolving stations with...

Current situation:
Kenwood TS-870 CAT Port PC COM1 (Ham Radio Deluxe as rig control / logbook) PowerSDR / IF Stage v1.19.3.5 (my visual front end panadaptor - also does rig control by point it to Ham Radio Deluxe

Current situation works, but I...

Hi,

I’m trying to use SDR Console V3 with Orbitron and PstRotator, and everything seems to be working fine so far. However, I’m having an issue updating the TLEs in SDR Console.

When I click the “Reload Now” button under Satellite Tracking Options...

I admit I am a cheapskate.
One of my current endeavors is to setup a low power UHF repeater on the cheap. What functionality is missing from current SDR options that make this impossible?
Cheers,
BS

Salve, volevo sapere magari se c'è da qualche parte qualche impostazione da settare per la ricezione. A volte ascolto degli OM con rumori sulla trasmissione, ma se verifico con un altro sdr questo non accade....solo con SDR CONSOLE....grazie

I am running v3.4 with a sdrplay rspdx.l noticed that my 40 meter band does not end at 7.300. Is there a way to set my location like my grid square, iTunes to maje my bands use the correct band plan.i have it hook up to my ft-891 with omnirig.
Hope...

Hi, with elad fdm duo if I play an audio track and then send it to transmission to be listened to the audio track is heard low and with noises as if I had some high gain level.....

If I listen to the file with Windows the track sounds great but...

Hi everyone,

I'm experiencing a display issue in SDR-Console v3.4 while using an ANAN Hermes (OpenHPSDR) radio.

The Problem:
Whenever I go into transmission (either by clicking the TUNE button or via PTT), the main spectrum/waterfall display drops...

Good morning, I'm explaining my little problem again, Brick-2 configured as ANAN-10-Hermes everything works except that if I go into transmission the power goes out I can make QSO but I DON'T see the filter in TX on the Panadapter, the span goes...

I am using W7 for ages to run my Lime SDR QO100 station. Never issues...

Today it came with a dialog box when trying to start:

SDR Console.exe - Entry point not found

The procedue entry point GetSystemTimePreciseAsFileTime could not be located...

Hi,
Sorry I’m new to the forum and posted a blank thread earlier.

I’m experiencing low sensitivity with an AIRSPY HF+ Discovery when using SDR Console v3.3 build 3236. Are there RF Gain, Sample Rate and Decimation adjustments somewhere in this...

Hi, I’m new here on the forum.

Hello folks,
I am using SDRC V3.2 as a remote panadaptor.
In the remote shack, I connect RSP-1A to IF output of FTDX5000 and run the SDRC server on a server PC.
On the client side, I can use SDRC as Panadaptor syncronizing VFO-A of FTDX5000 via...

Hello Simon, et. al.,

I'd like to offer my encouragement and perhaps other to further the development of a G2 Radio Definition for SDR Console. It seems more development is coming from Apache Labs along similar lines...G1 and the ANAN-G2-1K 1000W....

Hi,

Will blame my ignorance on old age now.

Truly great software.
Thanks so much for making it available.

The Simons Map is great.

Would like to get started with the SDR Television APP.

Is there a user guide, or anything similar, to help an old...

--19-- Peace be with us.
Since yesterday, I have not been receiving a signal. The console starts up, the USB 820T dongle loads, but there is no signal. When I stop the device, the software freezes. I deleted the device drivers, reinstalled the...

Good evening, I purchased the BRICK A 16 BIT today and I also have 3 other SDRs including the Hermes Lite, since I use THETIS with the Hermes I wanted to use the same software with the BRICK 2 but which one to download?? Always the one from MIO...

This is probably not a supported problem but I post wondering if someone has any ideas.

So I want to use a 20 foot USB-C cable with PD (power delivery). So I have one cable on my computer that supplies both power and devices from the distant USB...

Hello, I'm running Console on Linux Mint, using Wine. It installed fine, no errors and runs fine. I have also installed SDRplays API V3.15. When start Console, I'm prompted to find my SDR device, I go to Definitions, SDRplay and I have the option of...

Is there a way to get the map to fill the screen when maximized? Mine always has a black space to the right of the map.