It's all about the Software

Good evening, I purchased the BRICK A 16 BIT today and I also have 3 other SDRs including the Hermes Lite, since I use THETIS with the Hermes I wanted to use the same software with the BRICK 2 but which one to download?? Always the one from MIO...

Are there any plans for SDR Console to work with the AOR AR5700D?

AR5700D.png

Hello Friends,

Anyone of you use the card like this SDR 70 MHz-6 GHz Zynq7010+AD9363 with the SDR- Console software ?

Is it possible to manage the 2 RTX channels independently ?

I would like to use it as an RTX driver for an HF radio with IF at...

Hi folks,

anyone tried the HamGeek 70MHz-6GHz Zynq7010+AD9363 (link below). I am intrested in qo-100 operations with that board.

73, Holger DG3FEH

Hi, I use a Transfox SDR by Sigfox, but it is not supported by SDRC. What can I do ?. Tks

This looks like a very interesting new SDR It would be nice if SDRC supported it in the future.

73
Roland

win11 vs console, win 11 wins 🙁
I had to discard my old win7 pc, win7 not support, hardware issues due to age and some obsolete drivers... But it worked flawlessly with wsjt... New PC with win11... Months of frustration. I can make qsos (wsjt) until...

Has anyone used this software to control the russion Malahit-DSP SDRs?

if so, what settings are you using?

Hi

Has anyone managed to get the RS-HFIQ working with SDR Console? I much prefer this software than the recommended HDSDR

A very wonderful ARINST SDR Dreamkit V1D has appeared. Planning to support your receiver using the SDR Console?

Will SDR-C work with the Proficio ( SDR Transceiver?

73,
Robert

I see receiver Commradio CR-1a support on screenshots on the site, but cannot find it in the program. May support be discontinued?

The Icom IC-7610 can provide external SDR support via its USB port on the rear of the radio without the need for an external SDR device such as an SDRPlay. I am currently running HDSDR software perfectly via this connection. Will...

Hi,

Thank you to all who have contributed in this great work.
I wonder what it takes to implement OpenHPSDR Protocol1
transceriver through USB 2.0 interface? Through HPSDR
USB 2.0 OZY module -

Hi Simon, is it planned to include the Ailunce HS2 to the supported radios ?.
I use one and it would be fine to work with it via the QO-100 satellite with
Up- and Downconverters. Find the option nice that V3 can correct the
frequencydrift ...

73´s,...

Will it be supportet at some time?