SELECT Receiver with CAT command
Posted: Thu Apr 03, 2025 1:11 pm
Goodmorning everyone,
I have implemented a CAT control with ESP32 and Encoder for VFO setting.
Is there anyway to select a receiver that I have create in SDRC ?
With CAT command FA, FB, FC etc.. I can set the frequency but is not possible to Enable or switch to correct receiver.
Thanks a lot for support.
-73 de IW2MXE Diego
I have implemented a CAT control with ESP32 and Encoder for VFO setting.
Is there anyway to select a receiver that I have create in SDRC ?
With CAT command FA, FB, FC etc.. I can set the frequency but is not possible to Enable or switch to correct receiver.
Thanks a lot for support.
-73 de IW2MXE Diego