Search found 5 matches
- Mon Feb 21, 2022 7:59 pm
- Forum: Hermes-Lite 2
- Topic: HL2 + audio setting
- Replies: 1
- Views: 1334
HL2 + audio setting
I have always been HL2 working with Spark SDR. Now running SDRC 3.1 with HL2 together with WSJT-X and all working fine. One thing I cannot figure out is how to hear WSJT-X over the pc speaker. I have now RX set to VB-Audio virtual cable. If I change this to speakers or default I do not receive anyth...
- Sat Jul 17, 2021 12:21 pm
- Forum: Interfacing
- Topic: FT8 on Hermes Lite 2 (or any other SDR TX)
- Replies: 11
- Views: 4603
Re: FT8 on Hermes Lite 2 (or any other SDR TX)
Receiving FT8 in SDR Console with WSJT-X and HL2 all fine. TX not yet working. So far I configured SDRC by setting the output pins and enable onboard power amplifier (both under HL radio configuration). If I look in Transmit / DSP I see IPA and ALC output but no Power output when I use Tune (drive =...
- Tue Jun 29, 2021 10:42 am
- Forum: Interfacing
- Topic: FT8 on Hermes Lite 2 (or any other SDR TX)
- Replies: 11
- Views: 4603
- Sat Jun 26, 2021 9:54 am
- Forum: Forums
- Topic: FAQ/ Tips for New Users.
- Replies: 10
- Views: 7310
Re: FAQ/ Tips for New Users.
Is it possible to change my username?
- Sat Jun 26, 2021 8:50 am
- Forum: Interfacing
- Topic: FT8 on Hermes Lite 2 (or any other SDR TX)
- Replies: 11
- Views: 4603
Re: FT8 on Hermes Lite 2 (or any other SDR TX)
Max, if you do not mind and continiuning my quest from the HL2 forum. Current set up HL2, SDRC and WSJT-X (SDRC and WSJT-X lastest version). I have managed to receive FT8 messages into WSJT-X from SDRC. However when performing the CAT test is failed and with following message See below. Also in WSJT...