It's all about the Software

Hello, I detected a bug, when changing TX filter setting e.g. from 2k7 to 2k9 for some testing... If I want to change it back from 2k9 to 2k7, the TX settings still using the increased bandwidth settings. This problem happens for all version of V3.3 and also earlier V3.2 versions. Used radio is a Pl...

Hello,
understood your recommendation!
But still the same issue, here (as expected).

Will roll-back to 3.0.26.

Best regards,
Ruediger, DH1RK.

Hi, as mentioned, without changing any HW, by use/pressing the "Start" button in the home menu SDR console works. HW setup is not changes since 3.0.26. Pluto is powered just by mid USB port from USB hub. I have no problems during normal operation, so do not believe that it is a problem of ...

Hello, after update from 3.0.26 to 3.0.27 I always get an error dialogue at startup of SDR Console. Manual press of Start button in the home menu, starts the device. Version 3.0.26 could start directly one of my 2 two devices connected per USB. Both are Adalm Pluto devices version B. StartupError_wi...

Hello, thank for your feedback, but in my opinion it is just a workaround... Yes, I also used these two calibration factors, due to different IF. Will check, it again, but I think will behaves in generally the same. In addition, I detect, that also the setup for external PTT interface not working, t...

Hello, problem: Initial correction of SDR calibration not applied to Software at startup! Using Correction factor of 2.044 ppm. Visualization: QO-100 Middle normally at 10489.750 but at startup (without any interaction) is active on 10489.729x Also "Geostationary Satellite Beacon" window, ...