It's all about the Software

Here's a link to a commonly used Virtual Serial Port: http://k5fr.com/DDUtilV3wiki/index.php?title=VSP_Manager Thanks Jim, I've bookmarked that site in case I can't get VAC working. I have an old copy that I bought a few years ago from use with HRD, for some reason I don't remember now, but must ha...

Lack of search is down to the website engine - duda.co . I could add search but it would cost me ~$100/month. I run on low revenues, especially since COVID for some reason, so $100 is considerable. OK Simon, No problem. Max located what I was looking for. I must have stumbled over it randomly searc...

Max wrote: ↑Mon Apr 04, 2022 10:54 pm Here's the page you are looking for and yes, I agree that particular one is perhaps not in the most logical place:

https://www.sdr-radio.com/cw-skimmer#VirtualAudioCable

Thank you, Max,
That's the one I was looking for!
Cheers - Dave (G0DJA)

This isn't about the Forum per se, but I couldn't see anywhere else to ask. I can search the forum for key words, but I can't see a way to do that on the website. For instance, in my search for Virtual Audio Cable information (I still can't find it and I'm sure there was a link to two sources of VAC...

Still not been able to find it. Maybe it was on an external site?

However, going back to my original question. Can SDR-Radio get I/Q data from the IC-9700?

It wasn't even that. After a game of "close that, open that, close that" I found out that the RTL-Dongle had stopped working. I changed the RTL bandwidth, so it started working again, and closed and then re-opened SDR-Radio and it worked again. The problem is that I'm trying to use two rad...

However, I have completely confused SDR-Radio now. The display says 50.313MHz in one part and 1296MHz in another.

I found out why SDR-Radio would not reconnect to the 7300. I had another program (WSJT-X) running that was using the COM port.
I'm on another steep learning curve. LOL.

Well, I got SDR-Radio to recognise the 9700 by using "RIG2" in Omni-Rig, but now I can't get it to go back to the 7300...
I tried removing the 9700 from "RIG2" in Omni-Rig but the display still shows the 9700 display.