It's all about the Software

Simon G4ELI wrote: ↑Mon Oct 30, 2023 5:53 am Sorry, there isn't

Thanks Simon , ISS has been a little bit active for a few days .

Is there a AOS time (acquisition of signal) in world map for satellites , been looking and can not see . There were rats, rats, big as bloody cats, In the store, in the store. There were rats, rats, big as bloody cats, In the Quartermaster's store. [Chorus] My eyes are dim, I cannot see, I have not ...

Just in case anyone is interested as a follow on re: the splitter , 1st screenshot is sdrc parked on 7138Khz and sstv being sent out on 7171Khz using 150W 2nd screenshot is sdrc "on" the same frequency while TX sstv still using 150W On TX the radio (Yaesu FT2000D) disables RX by disconnect...

OTHR (over the horizon radar) today on 20m , shown is just after they switched beam direction as it was 10+ over s9 just previously as it took me awhile to locate the screenshot button , now as typing this its down to S3 after another change , talking about wide! Its good how the software can show t...

Hi , i guessed that was what you were really asking (why does not the software do it) , but if anyone else needed to know how the rough basic way is there :) and these days on SW/AM frequency accuracy is pretty good as i cannot recall one being off frequency for a very long time (i do a lot of VFO s...

I only found out a few days ago that that also works for the zoom factor on a memory so one can have a specific zoom level for a specific memory , on some of the memories i have they are jammed in amongst several high power SW stations and was continually zooming in on the band after clicking a memo...

Find a AM SW station , click SAM , then use the scroll wheel on mouse in frequency window on say the 100's khz (pick whichever you like) then move 100 or 500hz and you will hear a pitched noise as SAM re-locks on to it , then to check the offset click usb or lsb adjusting to zero beat and that'll be...

Version 3.3 Build 3048 , i just updated to the latest version August 1st 2023 and very nice . I really like the auto upgrade feature (one just runs the downloaded exe) and so far it does not mess anything else up like the saved memory's and Markers :D Just a side note listening atm on 40m SSB to a l...

As your probably aware? MMSSTV has been updated a bit into the 21st century by some EA's over there in Espania , the latest version is 1.13.3 and is on the EA's website http://radiogalena.es/yoniq/ and use a translator , YoniQ does have some quirks still . The YoniQ mode is propriety to this version...

RSPdx , after it was sitting around for a month or so unused , i plugged it in and fired up sdrc and the noise floor indicator needle was at a 8 and the s-meter needle was stuck at a S-9 and nothing i did (adjusting rf-gain/if gain) would get them any lower even with no antenna , then i faintly reca...