It's all about the Software

Hi Simon, I could use you help on this issue I am using Version 3.0.24 of SDRC with my Elad S2. When I set the SDRC attenautor on or off, I see and hear no difference in the signal strength or in the audio level? My noise level is high around here at S6. Using the Elad native software, I see and hea...

Hi Simon,

No wonder your signal on 40m sounds warbling. Always something in the radio hobby. Even if ones hobby was reading, I am sure gremlins would sooner or later case havoc.

Take care on the roof and thank you for all you do!

Funding FROM the users not FOR the users. Lol

Hi Simon,

Maybe a subcontract to Youssef with funding for the SDR Console users. Seriously, I was impressed with the video clip. Take care.

As if Simon isn't busy enough, here is something that is a game changer.

Check out this 32 second clip.

https://t.co/rjBTuk16Kg?amp=1

This would be great in any sdr console.

Greetings, I could sure use some help trying to identify as shown in the attached pictures. This interference occurs in the 2 mhz, 7-10 mhz, and 16-20 mhz bands and to a minor amount elsewhere on HF. I have had this problem before. I have walked the neighborhood with a portable Sony SW receiver. On ...

Hi Max,

Agreed, however, I was trying to have it jump to the next frequency (channel) without the mid-point that doesn't have any chance of having a station.

Notice that 100 khz and 200 khz are options, for example.

Hope you are well. Take care,
George

In the new version 3.0.25, I note there is a drop down selection for step rates. Wonderful! I saw another post where someone recommended adding 20 khz to allow tuning repeaters in the VHF/UHF amateur bands in the western USA. I know in the eastern USA, 15 khz separation is used. So please add 20 khz...

Hi Simon,

All is fine now. It took about 45 seconds from the time choosing Elad to it was running. Now it only takes about 7vseconds to start.

Thanks so much.

George

I installed Console 3.0.24 on my Win 10/win 8.1 dual boot computer. It found the Elad data it supposedly needs to run the Elad S2. However, I get error messages saying there are unhandled exceptions in net framework. I would send a screen picture, but since Console froze up, there was no wY to take ...