It's all about the Software

Has anyone looked at this bug yet? Below is what is happening. I have the application set to auto start the radio and track using OmniRig and that is what happens. This was not happening with the earlier stable versions of the application. It always started up quickly. sdr.PNG Simon is going to loo...

I had hoped there would be a simple solution rather than Key- tone generator- mic in on USB. Many thanks for quick reply. Bob 73 & VA Ah, yes, I see. Then sadly from what I have read on here there is no native CW mode for Pluto so the only option is to use one of those softwares to send tone to...

Bob, there will be different solutions depending on your hardware. What is your (or proposed) SDR? 73 Max Just re-discovered this thread worth a read through regarding Pluto and Lime for example where you would key, as you said, via SSB audio input. If you have Hermes Lite 2 (like me) then this has...

So gentlemen, I can not find an answer in FAQ's on this issue, so I would like to ask the many users with far more knowledgeable and experience with SDR Console a seemingly simple question. With both a CW Transmit mode and the ability to generate variable tones, can SDR Console easily be hardwired ...

When CW mode active, a means to park the peak of the CW signal in the middle of the filter window, like many HF transceiver's can do. I think it's essentially a search for peak signal strength +/- from the current VFO. Also the ability to choose CW mode side-tone. Therefore when using the CW Tune e...

I know it's not the same as what you are requesting, but have you considered a midi controller? Many commands are configurable to such a controller with tuning wheel and buttons. Also, a couple of shortcuts........ did you know that you can tune frequency using the keyboard left-right (x1 step)/up-d...

equipment is sdr play duo ic 9700 and ic 7300 these settings all stay the same no matter which identity I chose. 1 Radio selection omnirig maybe more but these are the ones I notice at the moment Max. Regards Brent Forgot the Omnirig settings! I'm not sure Simon can get those to save with the ident...

equipment is sdr play duo ic 9700 and ic 7300 these settings all stay the same no matter which identity I chose. 1 Radio selection omnirig 2 offset frequency 3 rf gain 4 if gain 6 agc 7 visual gain 8 tuner a/b maybe more but these are the ones I notice at the moment Max. Regards Brent By "Offs...

HI max thanks for the reply, yes i need two identities one for hf and one for qo 100. so i have one id called 7300 and one called qo 100. but when i get each one set up and then swap to the other one the settings don't change eg rf gain, offset frequency tuner A or B etc etc. I must be missing some...

Hi Sam. Afraid it's me again (Max). I assume you already tried raising the baud rate one step at a time on both the radio settings and Omnirig? I don't believe it's likely to be an issue with Omnirig. I have used it with other software that needs it at higher rates (not an external rig admittedly). ...