It's all about the Software

Hi together,

while receiving signals from QO-100 and I open another programm the audio gets distored for a few seconds, espsecially when the software gets startet.

I am using the SDR Console with a RSP1A SDR and a notebook with Intel(R) Core(TM)...

Hi together,

while working with FT8 I am using the signal transfered from the SDR Console to the WSJTX software by a virtual audio cable.

After some transmissions the audio connection breaks down and the FT8 software didn't get any audio signal....

I am new to HL2
The first board did not work and I ordered another.
I tested now with new board and have no output when tuning.
OP power set to 8 for not getting again a defective output
So finaly I tested with straight key.
I have 2 watts output...

Hello,

Does anybody solwe this problem?
It's possible to switch off the LO of TX while receiving on the same freq (simplex mode)?

Rgds

mario

SQ5cyn

B205mini_no_TX.JPG Hi,
I'm trying to get my B205mini usrp to work in the TX menu. RX is working fine with this SDR.
The Transmit DSP is greyéd out, meaning I can't make any selection. None buttons are selectable.

In the radio definitions there is...

Hi Forum

I cannot find any information regarding the signal used when I press TUNE in USB mode.

In the settings I can only find the option pulses/steady tone ...

Where can I control the tone frequency and level used in TUNE mode?

//Dietmar

Now working on a voice keyer, stay tuned.