It's all about the Software

I'm just getting started with SDR Console working with my LimeSDR USB device. I have tried to set up the SDR Server Manager but it cannot find the LimeSDR when I Search in the Radio Definitions panel. Is LimeSDR supported by the Server Manager app...

Hi, all:

Does the Server Map show the SDRC servers that are online? I've never seen anything there, other than the list form.

I tried searching the board, but the search term server map only returns this...

Information

The following words in...

Hello,

I've been playing with the server lately. I recently relocated and have more room and a quieter location. So I decided to use some of my spare SDRs as servers.

It wasn't too bad and I found answers to almost all of my questions on this...

Hi @ all,
i installed the Server Manager and there is a limitation to 1 mhz. Is there a possibility to change it to 2 mhz in a config file oder something like this?

Manuel

Hi Simon and all.
When trying to make Scheduled Recordings via a server connection I get Timeout error when the recording is about to start.
SDR-Console 3.0.27 Build 2143 on a Dell Laptop i7 6920HQ on Win10 OS.
WAN connection is 100/100 Mbits/s at...

I have a server with one radio & one account. It is setup to allow only LAN connections & works well.
However, I can only make one connection to the radio. Another client cannot connect because the radio is in use .
Is this normal? I had hoped I...

I am using a Airspy HF+ with a remote server on my LAN. If I use SDR-Console server the receiver sensitivity is significantly lower than it should be. Using the same radio with Spyserver, the sensitivity is as expected. For this comparison all the...

Hi

I have the SDRplay, RSP2pro connected to SRDC server. Another PC is running in normal mode and audio (VB-audio) is connected to WSJT-X or MHSV. When I start the session the delay DT is approximately 1s which is on the limit for decoding. WSJT-x...

Good afternoon.
I have a SDR Console running with a Pluto for QO-100
I would like to access that from remote.
The software locally is running and I can RX (and TX) QO 100.
I did all the procedure to run the server manager, and I can access from...

Greetings-

I have SDR Server 3.0.25 running at our club base station serving a SDR Play RSP1A. The system is fully functional on the LAN.
Remote access is possible with SDR Console from the outside world (internet) with the radio definition being...

Er, Simon... Shout here when you have any DSP-related questions . I've just discovered that KiwiSDR has implemented something John Seamons calls SAS .
My dream AM-DX demodulator, it uses the phasing method for sideband selection to reconstruct...

Hi Simon, is there a plausible reason why we cannot add a ANAN in the Server?
Anan is missing in the Servers radio's list.
regards, Leon

I was trying to get a better SNR on a pirate? radio station on 3935 in LSB running about 4 kHz wide. So far, I can only make out the words Classic Rock in the ID.
I connected to all available servers nearby US and CA as far away as 2000 miles, all...

Hi all.
Slightly off topic, but still close to the usage of SDRC.
Does anyone on this forum have experience in Port Forwarding with the Ubiquiti Edge Lite router with the user interface EdgeMax and the OS EdgeOS?
I have a LAN with two branches...

How do I connect to a server running on my local lan?
Thanks,
Gordon - N1MGO n1mgo at arrl . net

SDR-Radio DX Cluster no longer works

Hi,

Fixed a couple of issues I hope:

Found where the server could lock up if two or more threads accessed the security database simultaneously,
Security database lookup now much faster.