Scheduler / Recordings fail v.3.0.23 - 3.0.26
Posted: Sun Dec 27, 2020 12:45 pm
The scheduler refuses to take consecutive recordings.
Hi all,
Regarding the "recording situation": I operate a 12V station with solar batteries and therefore have to save electricity. A previously programmed recording starts properly. The NUC is then put to sleep and starts again at the next point in time. With all versions of the SDR console from .23-.26 that I have tested, the follow-up recording will not start. The STOP button is then activated. Only after deactivation (click the STOP button) is it possible to make another recording. Where could the cause lie and how can it be eliminated? Possible: the USB port is not recognized by the console after the start (ELAD FDM-S2) OR the STOP button should be on START again after the end of the recording.
Hope someone can help.
73, Willi
Hi all,
Regarding the "recording situation": I operate a 12V station with solar batteries and therefore have to save electricity. A previously programmed recording starts properly. The NUC is then put to sleep and starts again at the next point in time. With all versions of the SDR console from .23-.26 that I have tested, the follow-up recording will not start. The STOP button is then activated. Only after deactivation (click the STOP button) is it possible to make another recording. Where could the cause lie and how can it be eliminated? Possible: the USB port is not recognized by the console after the start (ELAD FDM-S2) OR the STOP button should be on START again after the end of the recording.
Hope someone can help.
73, Willi