CW Side tone on Hermes Lite 2 plus

AlanZaur
Posts: 1
Joined: Wed Jan 06, 2021 7:15 pm

CW Side tone on Hermes Lite 2 plus

#1

Unread post by AlanZaur »

I am new to the forum, so forgive me if this question has been asked before. I checked the older postings and could not find any information.
I am using SDR-Console v3 with a Hermes Lite 2 plus. I have been pleased with it so far, but I have two issues that I cannot solve myself.

1. I am unable to get a CW side tone when I have the earphones connected to my PC. Is there a setting I am missing? The receiver audio is present and seems to function well.

2. I was unable to plug headphones into the Hermes Lite 2 plus and get audio out of any sort. I know I must be missing something, but I cannot seem to find it.

Overall, I am pleased with the software performance and the interface.

Max
Posts: 859
Joined: Thu Aug 13, 2020 9:47 am

Re: CW Side tone on Hermes Lite 2 plus

#2

Unread post by Max »

Hi Alan

I have regular HL2. Had no issues at all with the sidetone which works very well.

Did you set the options in the "TX options" menu? (see attached picture).

Otherwise I wonder if something specific to the HL2+?

The headphone audio jack on the HL2+ I cannot help with. Did you try the HL2+ group for support on that one? As I say, have stock unit here and after a few small issues very early on it is pretty much all sorted. Simon may offer help, but then again he may only offer support for the unmodified unit?

73

Max
Attachments
Sidetone.JPG

Post Reply