FLRig as External Radio ?

[KD7YZ Bob]

I'd like SDR Console to track my FT450 that I use for 6m digital work
Sdr Console reads an RTL whereby the signal from the yagi has gone thru an LNA.

Trouble comes when the FT450 is run by FLRig, which is not selectable as an external radio.
OmniRig clashes with FLRig.

Has anyone tried using FLRig as external radio?

73 Bob KD7YZ

[KD7YZ Bob]

I asked this about 6 months ago.
I would still like to use FlRig as an External Radio to control my rigs ... along with SDRC V3.1 which I am using with my SDRPlay RSPDuo.

Any hope for FlRig ?

[Simon G4ELI]

I asked this about 6 months ago.
I would still like to use FlRig as an External Radio to control my rigs ... along with SDRC V3.1 which I am using with my SDRPlay RSPDuo.

Any hope for FlRig ?

Why are you using FlRig and not Omnirig?

[KD7YZ Bob]

Look at the difference of rig "Control".

And many programs open Omnirgig as a service.
SDRuno is one. OR I call it a Service anyway ...in order to find and kill it, one must use Process Explorer or somesuch BEFORE one can again use FlRig.

[Simon G4ELI]

Look at the difference of rig "Control".

And many programs open Omnirgig as a service.
SDRuno is one. OR I call it a Service anyway ...in order to find and kill it, one must use Process Explorer or somesuch BEFORE one can again use FlRig.

You haven't really answered my question. Why use Flrig - which program requires this?

[KD7YZ Bob]

For one, WSJTx . I use the audio out from SDRC to Line#1 VAC. That Line#1 is the Audio Input to WSJTx (among other programs).

I would like to see the VFO sync with the frequency of SDRC's "RX 1"

My receiving for digital work is through the RSPduo .

[Simon G4ELI]

I use WSJT with SDR Console using VAC and it works fine, syncs with RX1.

[KD7YZ Bob]

Yes but then I have to use Omnirig.
Whereas I have pretty darned good control over the rig from FLRig, including a memory bank.