Hello,
Re the menu that comes up when going to:
Home/Frequency that allows you to enter Frequeny AND Span.:
Any way to have it stay on the screen permanently, rather than having it disappear after entering any new values ?
Thanks,
Bob
Frequency And Span Window Question
Re: Frequency And Span Window Question
Don't think so Bob, but just keeping your cursor over the waterfall or spectrum and pressing "Return" or Enter" key brings it up immediately.
Similarly, with cursor hovering as above, start typing frequency in keyboard numbers row or NumPad and you get the frequency entry box coming up instead (although it's the simplified one, not the one with "Span" available). That's the mode I use most.
Hope it helps
Best
Max
Similarly, with cursor hovering as above, start typing frequency in keyboard numbers row or NumPad and you get the frequency entry box coming up instead (although it's the simplified one, not the one with "Span" available). That's the mode I use most.
Hope it helps
Best
Max
Re: Frequency And Span Window Question
Should have said for the last of the two options I mentioned to work (direct frequency entry) you need to have box ticked as in attached picture.
Best
Max
Best
Max
From OP: Re: Frequency And Span Window Question
Hi,
As always, much thanks.
Sure is a lot to know, but fun.
Best regards, stay well,
Bob
As always, much thanks.
Sure is a lot to know, but fun.
Best regards, stay well,
Bob