Waterfall speed allow 12 hours for noise detection?
Posted: Wed Jan 06, 2021 2:49 pm
I have an RSP1A which I've used with SDRuno. I'm needing to run the WF for as much as 12 hours, either a coarse increment (which is fine as I'm looking to see if the noise level changes) or the ability to scroll back in time ... can Console do this?
Also Uno's WF is very poor, or at least I've not found a way around this, in displaying the WF re changes in level. I can change the signal level by 27 db - which on my Anan8000/PowerSDR shows like night and day - literally - on Uno you barely notice a change. Is Console set up to better handle WF allowing for setting the total range min/max?
I have severe noise coming from my house - 3 different antennas on 3 different towers and 3 different angles to the house all triangulate to OVER the house re this noise. It is very broadband - covers 12M up through 6M. And unfortunately shutting down the whole house (or at least the breakers) doesn't make it go away. SOMETHING is still powered and I need to find it. So far I've not had any luck in doing so.
thanks for your time - whomever replies.
Gary
K9RX
Also Uno's WF is very poor, or at least I've not found a way around this, in displaying the WF re changes in level. I can change the signal level by 27 db - which on my Anan8000/PowerSDR shows like night and day - literally - on Uno you barely notice a change. Is Console set up to better handle WF allowing for setting the total range min/max?
I have severe noise coming from my house - 3 different antennas on 3 different towers and 3 different angles to the house all triangulate to OVER the house re this noise. It is very broadband - covers 12M up through 6M. And unfortunately shutting down the whole house (or at least the breakers) doesn't make it go away. SOMETHING is still powered and I need to find it. So far I've not had any luck in doing so.
thanks for your time - whomever replies.
Gary
K9RX