Port Forwarding question

User avatar
sm6fhz
Posts: 179
Joined: Wed Aug 19, 2020 3:21 pm
Location: JO57XJ
Contact:

Port Forwarding question

#1

Unread post by sm6fhz »

Hi all.
Slightly off topic, but still close to the usage of SDRC.
Does anyone on this forum have experience in Port Forwarding with the Ubiquiti Edge Lite router with the user interface EdgeMax and the OS EdgeOS?
I have a LAN with two branches (192.168.2.1 and 192.168.3.1) with both a AFEDRI LAN and a SpyServer connected.
I can access both just fine anywhere inside the LAN but I can not find out how to open the ports to the outside world.
I have followed the manual in how to make Port Forwarding and I have searched the Internet for instructions, but no joy. All information found points at I have it correctly, but there still is a flaw somehow.
Scanning from outside the ports used for the AFEDRI and the SpyServer is not to be seen. Other open ports (the usual ones) are visible in this scan (using Zenmap). See attached screenshot.
It is probably something stupid and simple that is missing.
Any hints or discussions would be appreciated.
73 / Ingolf, SM6FHZ
Attachments
Zenmap_port_scan_Ubiquiti_Edge_Lite.PNG
Zenmap_port_scan_Ubiquiti_Edge_Lite.PNG (5.3 KiB) Viewed 1036 times

User avatar
sm6fhz
Posts: 179
Joined: Wed Aug 19, 2020 3:21 pm
Location: JO57XJ
Contact:

Re: Port Forwarding question

#2

Unread post by sm6fhz »

Hi.
I can add that I have tried to open the following ports:
5554
5555
50000
50101
50102

The only ones seen in the Zenmap scan have been 5555 and 50000 with the "filtered" state as shown in the screenshot.
73 / Ingolf, SM6FHZ

Post Reply