HRD-OmniRig-SDRPlay-SDR-Radio
Posted: Fri Oct 08, 2021 6:41 pm
Hi wonder if anyone can help.
I have HRD set to com3 and rig control is good. I set 3rd party rig control to com19 using virtual ports com19/20.
I then set SDRradio omnirig to connect to com20 and set track radio. SDR radio in the external radio pane follows the radio but the sdr radio RX1 stays at a given frequency. If I click on the frequency pandameter both the RX1 and external radio frequencies are set but the radio does not move to that point. So I have communication from radio to the external radio pane but it does not move the receiver of the SDRPLAY and SDR radio. I tried so many combinations but don’t know where I have gone wrong.
Any guidance would be great.
Thanks
Peter 2E0ZKT
I have HRD set to com3 and rig control is good. I set 3rd party rig control to com19 using virtual ports com19/20.
I then set SDRradio omnirig to connect to com20 and set track radio. SDR radio in the external radio pane follows the radio but the sdr radio RX1 stays at a given frequency. If I click on the frequency pandameter both the RX1 and external radio frequencies are set but the radio does not move to that point. So I have communication from radio to the external radio pane but it does not move the receiver of the SDRPLAY and SDR radio. I tried so many combinations but don’t know where I have gone wrong.
Any guidance would be great.
Thanks
Peter 2E0ZKT