Hi, I'm new to this forum and I hope I'm asking the right question on the right forum. In order to use my Adalm Pluto I have to download and start the program SDR Console (64bits). Downloading is not a problem, and after downloading the program will start automatically. However, when I try to choose a radio or just try to run the program everything freezes and I have to restart my computer before I can try again. Has anyone had and solved this problem.
Sincerely, Marco, F8VOA
SDR Console for Pluto
- Simon G4ELI
- Posts: 2138
- Joined: Thu Aug 06, 2020 7:27 am
- Location: Mawnan Smith
- Contact:
Re: SDR Console for Pluto
Probably USB power - use a powered USB hub or the second USB connector on Pluto to get more power.
Re: SDR Console for Pluto
Thanks Simon , but I'll wait for the results on the crash report I send you
73
Marco
73
Marco
- Simon G4ELI
- Posts: 2138
- Joined: Thu Aug 06, 2020 7:27 am
- Location: Mawnan Smith
- Contact:
Re: SDR Console for Pluto
OK,
Let's start again. Use the latest V3.1 beta, create a crash dump and send it to me. I have a few to look at, am busy this week and next with other code. Trust me - when a USB device freezes then 99% of the time it is power or driver.
Let's start again. Use the latest V3.1 beta, create a crash dump and send it to me. I have a few to look at, am busy this week and next with other code. Trust me - when a USB device freezes then 99% of the time it is power or driver.
Re: SDR Console for Pluto
HI, am running v3.1 my problem is i can get the 10Ghz up on the display but it will not convert to 10 ghz, it reverts back to the 700mhz freq i had selected.
Any ideas?
Dermot ei6fz
Any ideas?
Dermot ei6fz
- Simon G4ELI
- Posts: 2138
- Joined: Thu Aug 06, 2020 7:27 am
- Location: Mawnan Smith
- Contact: