AM mode audio oscilloscope display still borked
AM mode audio oscilloscope display still borked
Does not display symmetrically in AM mode, but does properly in all other modes.
Re: AM mode audio oscilloscope display still borked
Could it be from the SSB signal that is located just above the AM BC station?
I just noticed that the 40M Ham Band displayed is valid for IARU Region 1, but here in USA, we are IARU 2 where we get another 100 kHz:
https://en.wikipedia.org/wiki/40-meter_ ... U_Region_1
Where are you located that you hear Radio China International so strong?
73 Kriss KA1GJU
I just noticed that the 40M Ham Band displayed is valid for IARU Region 1, but here in USA, we are IARU 2 where we get another 100 kHz:
https://en.wikipedia.org/wiki/40-meter_ ... U_Region_1
Where are you located that you hear Radio China International so strong?
73 Kriss KA1GJU
73 Kriss KA1GJU Home of the KA1GJU Super Station SDRC Servers in NH, USA (FN42mw & FN43na)
Re: AM mode audio oscilloscope display still borked
Greg(?), please check if this 25Hz filter setting is checked.
regards, Leon
regards, Leon