In the new version 3.0.25, I note there is a drop down selection for step rates. Wonderful!
I saw another post where someone recommended adding 20 khz to allow tuning repeaters in the VHF/UHF amateur bands in the western USA.
I know in the eastern USA, 15 khz separation is used.
So please add 20 khz and 15 khz to the drop down menu. This would be very helpful for the hams on this side of the pond.
Thanks, Simon, for all that you do!
Regards,
George, NJ3H
Step Rates
Re: Step Rates
Hi George
Sorry to state the obvious but 7.5 kHz and 10 kHz are already there?
73
Max
Sorry to state the obvious but 7.5 kHz and 10 kHz are already there?
73
Max
Re: Step Rates
Hi Max,
Agreed, however, I was trying to have it jump to the next frequency (channel) without the mid-point that doesn't have any chance of having a station.
Notice that 100 khz and 200 khz are options, for example.
Hope you are well. Take care,
George
Agreed, however, I was trying to have it jump to the next frequency (channel) without the mid-point that doesn't have any chance of having a station.
Notice that 100 khz and 200 khz are options, for example.
Hope you are well. Take care,
George
Re: Step Rates
That'd be me
Both sides actuallyI know in the eastern USA, 15 khz separation is used.
So please add 20 khz and 15 khz to the drop down menu. This would be very helpful for the hams on this side of the pond.
"Thanks, Simon, for all that you do!
Bob NO6B