Dear all,
I am running SDR Console Server/Client configuration at my home over a LAN network (between a garden house <-> living room).
The problem is easy but frustrating. As soon as I launch the Console Client, I always need to set-up all the radio parameters (RF Gain, AGC Off, SMA B Antenna, MW/FM Notch On, DAB Notch On) again. Again and again. Every time I launch the Client. I am using SDR PlayDX.
If I run the Console on the Server side, all these radio parameters are stored/remembered.
Any help/idea please?
Thanks a lot.
Best regards,
M.