V (overload) LED operation
V (overload) LED operation
My Dragonfly was working fine for a few days. Overnight, with no changes in settings or antennas the V LED came on and remains on when the radio is active regardless of whether it has any antennas. It still seems to work otherwise. Is there a way to reset that?
Re: V (overload) LED operation
Hello James
This is the support group for the SDR software, SDR Console: https://www.sdr-radio.com/
You would be better posting this question in the "Next Generation SDR" IO Group:
https://groups.io/g/NextGenSDRs
You should get a response there as the designers of your radio are also active in that group.
73
Max
This is the support group for the SDR software, SDR Console: https://www.sdr-radio.com/
You would be better posting this question in the "Next Generation SDR" IO Group:
https://groups.io/g/NextGenSDRs
You should get a response there as the designers of your radio are also active in that group.
73
Max
Re: V (overload) LED operation
Unfortunately, there is very little traffic in the IO Group and no one has responded to me other than a suggestion to come here!
Re: V (overload) LED operation
I saw your post on io but didn't respond as I coudn't offer any advice. Which model do you have, googling Dragonfly RX103 throws up a tweet from 2020 but you say it's a variant? Which model is it and this LED, is it marked as V? A photo of the SDR would help a lot.
Re: V (overload) LED operation
I just took it apart, photos at https://www.dropbox.com/sh/cmcdnsj9gthx ... kX7va?dl=0
Re: V (overload) LED operation
Well I've not seen that one before! All I can suggest is if you get no luck anywhere else you tweet Justin as I think he's the source of many of these. https://twitter.com/fei666888