TX / FIR Filter Bug?

[INURadio]

Hi,

SDR Console 3.3 / Pluto Plus / CN-0417 Preamp / DX Patrol 12w Amp.

When I first power up the Pluto+ and run SDR Console I can’t get any TX power out on voice or tone. The TX button in SDRC changes colour and I am showing a modulated signal or tone with ALC in the red but I am just not putting out anything.

If I go to RADIO / TX Filter and change it up or down by any amount even 1 position SDRC does some sort of refresh and I can TX without any issue from then on. Until I power cycle STOP/START SDRC that is, at which point I have to cycle TX Filter again.

More testing has shown that if I start SDRC with a Bandwidth setting of 1.92 MHz or above, this issue doesnt happen. If I start SDRC with a bandwidth of 1.536 MHz or below that is when the problem above shows up.

Could this be linked to the "Analogue and FIR Filter Configuration?

Thanks.