ELAD FDM-S3 Bandpass Filter Configuration with V3
Posted: Thu Jan 21, 2021 5:12 pm
Hi,
Since few days I have the S3 here. Now I have install following Bandpass and Highpass Filters. See below.
I have configure the Filters in both Software exactly the same, but the result is not the same.
Console V3 Filter config SW2 Filter config If I have as example 24MHz bandwidth and tune with the SW2 above 1700KHz the Higpass is active and cut the range below 1700KHz. If I tune below 1700KHz the Highpass is deactivated. With the Console V3 I cannot see that the Highpass is active if the tuned Frequency is above 1700KHz. What I make wrong?
Thanks.
Regards
Fernando
Since few days I have the S3 here. Now I have install following Bandpass and Highpass Filters. See below.
I have configure the Filters in both Software exactly the same, but the result is not the same.
Console V3 Filter config SW2 Filter config If I have as example 24MHz bandwidth and tune with the SW2 above 1700KHz the Higpass is active and cut the range below 1700KHz. If I tune below 1700KHz the Highpass is deactivated. With the Console V3 I cannot see that the Highpass is active if the tuned Frequency is above 1700KHz. What I make wrong?
Thanks.
Regards
Fernando