Is the BladeRf V1 supported by Console 3.0.26
Posted: Wed Mar 10, 2021 9:12 am
I'm a VERY new Console user. I have a functional BladeRF + an XB200 with the following bits installed:
bladeRF-cli version: 1.8.0
libbladeRF version: 2.2.1
Firmware version: 2.0.0
FPGA version: 0.11.0
Should this radio work? When trying to Select Radio via Search, I select BladeRF v1 but get the error "Nothing Found - sorry".
Not sure this radio is actually supported as I don't see much info on the forums wrt the bladerf, if I must do some additional setup, or...
Is this radio supported?
I don't want to burn time if not so.
Thanks,
Rich
bladeRF-cli version: 1.8.0
libbladeRF version: 2.2.1
Firmware version: 2.0.0
FPGA version: 0.11.0
Should this radio work? When trying to Select Radio via Search, I select BladeRF v1 but get the error "Nothing Found - sorry".
Not sure this radio is actually supported as I don't see much info on the forums wrt the bladerf, if I must do some additional setup, or...
Is this radio supported?
I don't want to burn time if not so.
Thanks,
Rich