Page 2 of 2
Re: SDRPlay RSP2 won't start with V3.2
Posted: Tue Oct 22, 2024 7:53 pm
by avigdor6
What is (link?) Simon's web site?
Re: SDRPlay RSP2 won't start with V3.2
Posted: Tue Oct 22, 2024 8:51 pm
by avigdor6
I finally have it working with version 3.4 - I uninstalled the previous version and deleted its folder from C: . Installed 3.4, and it couldn't find the service. I had to reinstall SDR Uno. Finally, located the service and it is working. Now, I need to sync it with my Kenwood TS-590SG. Any tutorials on this topic?
Thanks,
Victor AA5IR
Re: SDRPlay RSP2 won't start with V3.2
Posted: Tue Oct 22, 2024 9:33 pm
by Max
avigdor6 wrote: Tue Oct 22, 2024 8:51 pm
I finally have it working with version 3.4 - I uninstalled the previous version and deleted its folder from C: . Installed 3.4, and it couldn't find the service. I had to reinstall SDR Uno. Finally, located the service and it is working. Now, I need to sync it with my Kenwood TS-590SG. Any tutorials on this topic?
Thanks,
Victor AA5IR
That's good to hear Victor. Well done for persevering. The installation procedure for SDR Play can be a little "fussy".
Regarding syncing with an external radio see here:
https://www.sdr-radio.com/external-radio
For general further help the closest thing there is to any sort of operation manual of sorts is to go to Simon's website at sdr-radio.com then float your cursor to the top of the page. There are a large number of drop-down menus and sub-menus with lots of information on how to use SDR Console. Sadly have to report that these notes have not been updated very much of late, so there are changes to quite a few features that may not be fully reflected in those notes, but it's generally a good place to start.
Any questions just come back here and ask.
73
Max