It's all about the Software

Hello Friends,

Anyone of you use the card like this SDR 70 MHz-6 GHz Zynq7010+AD9363 with the SDR- Console software ?

Is it possible to manage the 2 RTX channels independently ?

I would like to use it as an RTX driver for an HF radio with IF at 72 Mhz on channel 1
and for the other higher frequencies VHF-UHF-SHF on channel 2 of the SDR card.

Suggestions ? Thanks !
73 Arnaldo www.ik2nbu.com

IK2NBU wrote: Sun Mar 16, 2025 7:51 am Anyone of you use the card like this SDR 70 MHz-6 GHz Zynq7010+AD9363 with the SDR- Console software ?

Is it possible to manage the 2 RTX channels independently ?

Arnoldo, the picture shows the Zynq7020 version?

Simon is working on similar board at the moment, particularly for DATV:

https://www.sdr-radio.com/libresdr

https://www.sdr-radio.com/libresdr-revisited

As far as I know there's no plan to use the dual RTX channels. He has certainly not mentioned it.

73

Max

Without designing it from the git go as a dual channel SDR it's VERY difficult to make an single front end channel SDR into a multi-channel front end SDR. In the past Simon has indicated that this is not in the cards.

{^_^}

Thanks for your suggestions.

Arnaldo www.ik2nbu.com

I see that with SDR Angel Software + MIMO Plug In made by a France OM, maybe is possibile use 2 Channel RTX in different bands.
But SDR Angel and Plug MIMO is not easy to use.