It's all about the Software

Hello,

I am using SDR Console V3.4 build 3871 on Windows 11.

When tuning signals on the narrow band portion of QO-100 I can click on a station with the mouse, but as soon as I use the mouse wheel to fine tune the frequency jumps to 9.999.999.949. Additionally the frequency display is incorrect, for example the centre beacon shows 0.489.725.650 i.e. the 1 is missing out of the GHz range. When the frequency jumps to 9.999.999.949 all signals are lost. If I tune to the LNB output at around 739.781.425 I can tune in the normal way with the mouse wheel and receive signals.

I have attached a screen shot of the error.

Thanks for your help.

Dave G4EEV.

G4EEV wrote: Fri Nov 21, 2025 3:25 pm When tuning signals on the narrow band portion of QO-100 I can click on a station with the mouse, but as soon as I use the mouse wheel to fine tune the frequency jumps to 9.999.999.949. Additionally the frequency display is incorrect, for example the centre beacon shows 0.489.725.650 i.e. the 1 is missing out of the GHz range. When the frequency jumps to 9.999.999.949 all signals are lost.

I have attached a screen shot of the error.

No attachment seen here Dave.

Have you read this about QO-100 tuning on Simon's website?

https://www.sdr-radio.com/EsHail-2#Display10GHz

Max

Max,

Thanks for your advice, I changed the display for 999.9 and that has fixed it!

Thanks again,

Dave G4EEV.

G4EEV wrote: Mon Nov 24, 2025 7:36 pm Thanks for your advice, I changed the display for 999.9 and that has fixed it!

Thanks again,

Dave G4EEV.

Glad it helped.

73

Max

§Yes Max, thank you for that, Fixed mine too!

Bob G4MWR

MWR wrote: Sun Dec 21, 2025 11:10 am Yes Max, thank you for that, Fixed mine too!

Bob G4MWR

NP Bob!

Max