It's all about the Software

Hello,

I may be wrong about this, but I seem to remember some time back there was mention of
a dedicated, stand-alone program with many of the digital modes solely.

If so, has such a program been released, or status of ?

And, is there a...

My usual go-to, the 64-bit Google Drive share, wasn't working so I downloaded the latest release from the OneDrive share and then for the hell of it I also downloaded the DropBox one.

The digest hashes for the two files don't match. Is this...

I use the VAC from to output Line-1 .
Then I use Line-1 as the Audio source in WSJTx RC4.

When using FT8, I see delay (dT) of up to 2.5 seconds. Typically the delay is 1.0 to .15 .

So, when I run the same WSJTx and use my rig's USB-Audio-Codec as...

Hello,

How to download a new fm database and import in the program

David Visser

Here is a section of the log file shortly before the end of the recording:

04:54:49.024: Data Recorder> D:\18-May-2021 035506.007 1.200MHz 022.wav
04:55:04.049: Data Recorder> Scheduler timer
04:55:04.050: Data Recorder> Calls ........: 14400...

I am running a Windows 10 PC with a RTLSDR dongle and a SpyVerter. I am trying to tune HF around 1.310 MHz. I select UP 120 MHz to up convert the HF frequency to something that the RTLSDR can tune. When I do that I find I am tuning in an VHF/UHF...

Hi there,

mainly I'm using v3.0.27 with an NooElec Nooelec NESDR SMArt v4 (RTL2832U & R820T2) Dongle to receive POCSAG Pager messages.
So, I want to use 2 sticks to decode different frequencies - I ordered the little brother NooElec NESDR Nano 2...

The signal I am testing/visualizing is an uplink cellular phone rf signal, but regardless of the signal type, there is a significant RF signal strength difference between what I can see in the Console vs a Realtime Spectrum Analyzer (multiple RTSA...

Hi ,

I have lost , the blue color on the spectrum
Someone can help me to restore it ?

I have the blue color on the waterfall

Is it possible to Average/Integrate Spectrum buckets with Console? Air Spy has Astro Spy and other applications support averaging for a given sample count. Thanks and enjoy, John.

EDIT: I am running 3.0.27 Preliminary on an Air Spy. I tried...

New LAN-IQ Owner searching for SDR control software - SDR Console v3 appears to work and is promising. However install footprint seems huge (600+ Mb?) - Any way to determine minimum disk space & files needed for a single radio?

Thanks.

Hi,
Using SDR-CONSOLE with multiple dongles, is it possible to have more than one fully working radio on the screen at the same time?
Cheers, Camerart

I was exploring some of the neat changes that can be made via options and was delighted I could tweak many to my liking to make my RSPdx play even better. But when I closed console down and restarted it some stayed but many went back to default. Is...

Hello,

Just getting set up with a new CloudSDR (as Simon is aware from my ramblings in another group). I am a big VHF and above searcher and DX'er and using CTCSS and DCS tones to identify unknown stations is a big part of that.

I notice under...

Hello,

Have been trying to fit some of CSVUserlistBrowser, and what I normally have showing in Console (when not using CSVULB) all on
my pc screen. Dragging an edge just cuts stuff off. Running W10.
A real battle.

I know that the screen...

Is there a way to interface the Icom IC-7300 and HRD and SDR Console for use at the same time? If so, please elaborate...my email is w4jcwjohn@gmail.com

Having problems with AM & SSB reception with an RSP-1a whenever I reduce the RF gain below 6: very distorted or no audio. It sounds just like a biasing problem with an op amp when the DC bias point shifts toward one of the supply rails. Everything...

Hi,
What is in your opinion the best setting for IF gain when recording I/Q over a 2Mhz frequency range? Auto or manual ?
Regards
Michel (F1GOC)

Hello. I can't get my sdr console to work. I need help! Looking for expert to help me using team viewer or zoom. I can pay a reasonable hourly rate. Please contact me at dcee123@protonmail.com. Thanks.

Hello

Back in January when I started using SDR Console with my Air-spy HF+ Discovery for NDB hunting I created recording files that were 20 GB in size.

Later I learned to split my recordings into 2 GB files.

Is there any way to split a 20 GB file...

Now we're in Summer time I'm seeing a discrepancy (when replaying recorded files) in the time stamp on the waterfall, which is showing correctly as UTC, and the time shown in the the bottom left box of the waterfall and in playback navigator. Both...

Hello,

I know about the auto center with Zoom.

But, is there any way to have a selected freq., via the mouse button, be automatically centered in the Spectrum view ?

Thanks,
R.

I am using a SDRPlay RSP1A linked to the Slave port of Logger32 and the IF output of an FTdx5000 as a panadapter.
When I click on a DX spot in Logger32, it sends the FTdx5000 to the correct frequency then sends that frequency to SDRC via the Slave...

Good day! Installed SDR Console version 3.0.26 along with SDRPlay RSP1A on i9 7900x / 32GB RAM / SSD M2 + HDD / NVidio GT710 / Win2019 Server computer.

Everything started up and worked great!

This is my first experience with SDR, ... after viewing...

When I run SDR-Console it's full screen. How do I make the SDR-Console window sizable?